Vxl-instruments Itona Md75 Series Manual do Utilizador descarregar pdf (Página 12)

Replacing RAM 8

5 Replacing RAM

1. Remove the power cord and top cover as described on page 5.

2. Apply isopropyl alcohol on the glue holding the DDR3 RAM; pull the glue out using nose

pliers.

Figure 5-1: RAM Socket Clips

3. Remove the existing RAM from the SO-DIMM slot by unlocking the holders and pulling it

outward.

Figure 5-2: Removing the RAM Module

4. Place the new DDR3 RAM in the SO-DIMM slot.

Note: Ensure that the new RAM is of the same specification as the existing RAM.

5. Slide the RAM into place until the clip snap-fits at each end of the SO-DIMM socket.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Sem comentários

Vxl-instruments Itona Md75 Series Manual do Utilizador Página 12