Vxl-instruments Itona TC61yy Series Manual do Utilizador

Itona TC61yy Service Manual

Replacing Connectors and Cables 6 4 Replacing Connectors and Cables Replacing ATX Power Connectors 1. Remove the power adapter and side cover . For

7 Replacing Connectors and Cables Replacing SATA Cables 1. Unplug SATA power cable as shown in Figure 9. Figure 9: SATA Power Cable 2. Unplug the

Replacing SATA Hard Disk 8 5 Replacing SATA Hard Disk To replace SATA hard disk: 1. Remove the power adapter and side cover . For more information

9 Replacing SATA Hard Disk Figure 13: SATA Hard Drive Bracket 4. Remove the rubber bushes and Mylar sheet. Figure 14: Rubber Bush and Mylar Sheet

Replacing RAM 10 6 Replacing RAM To replace RAM: 1. Remove the power adapter and side cover . For more information see Removing the Side Cover on p

11 Replacing RAM 4. Place the new RAM on the socket. Note: Ensure that the new RAM is of the same dimensions as the existing RAM. 5. Slide the RAM

Replacing the Motherboard 12 7 Replacing the Motherboard To replace the motherboard: 1. Remove the power adapter and side cover. For more informati

13 Removing the Power Supply Unit 8 Removing the Power Supply Unit To replace the power supply unit: 1. Disconnect the ATX power supply cable as sh

Removing the Power Supply Unit 14 Figure 21: Power Supply Unit 4. Remove the wires connected to the power supply unit. You may replace a new unit

Copyright © 2004-2013 VXL Instruments Limited. All Rights Reserved Information in this document is subject to change without notice and does not rep

Table of Contents 1 Tools Required 1 2 Thin Client Bracket 3 Removing the thin client from the bracket 3 3 Removing the Side Cover and Bezel

Warning and Caution Statements Warning: It is best to wear an electrostatic discharge (ESD) cuff when handling electronic components (Motherboard

1 Tools Required 1 Tools Required The tools required for servicing the Itona TC74yy Thin Client are shown in Figure 1. Figure 1: Tools Required

Tools Required 2 B. Phillips screw driver C. Hex Nut driver 5.0 mm D. Nose pliers with spring

3 Thin Client Bracket 2 Thin Client Bracket Removing the thin client from the bracket The procedure to remove the thin client from the bracket is ex

Removing the Side Cover and Bezel 4 3 Removing the Side Cover and Bezel The procedure to remove the side cover and front bezel of the client is expl

5 Removing the Side Cover and Bezel Figure 6: Front Bezel Fixing the Bracket and Side Cover To fix side cover and power adapter: 1. Gently press t